GM Front Impact Crash Sensor (No Body Lift): APDTY 601313

APDTY 601313 is a brand-new front impact crash sensor for select 2003–2004 GM full-size SUVs and pickups, mounting on the radiator support at the front left or front right — for models WITHOUT a factory 2" body raise. It replaces GM numbers 85598001 and 15057506.

Key Takeaways

  • What it is: a front impact/crash sensor — an SRS airbag-system component that mounts on the radiator support.
  • Critical fitment check: this sensor is not compatible with models that have a factory 2" body raise. Those models use a different sensor, APDTY 601316.
  • Fits: 2003–2004 Escalade, Avalanche, Silverado 1500/2500/3500, Tahoe, Denali, Sierra 1500/2500/3500, and Yukon — front left or front right position.
  • Safety: this is an airbag (SRS) part. Diagnose with a scan tool and follow factory SRS procedures.

APDTY 601313 front impact crash sensor for 2003-2004 GM trucks without 2 inch body raise

Check current availability and buy APDTY 601313 directly from APDTY

What does a front impact crash sensor do?

A front impact (crash) sensor detects the severity and characteristics of a frontal collision and reports that information to the airbag control module, which uses these signals to decide whether and how to deploy the airbags. It mounts to the radiator support, on either the front left or front right, depending on the specific application.

What are the symptoms of a failed crash sensor?

A faulty or damaged front impact sensor may cause:

  • An illuminated airbag / SRS warning light
  • A stored SRS trouble code referencing a front impact sensor circuit
  • SRS faults after front-end collision damage or corrosion at the mounting location

A crash sensor is commonly replaced after collision damage or when diagnosis traces an SRS code to that sensor or its circuit. Proper diagnosis is required before replacement.

Does APDTY 601313 fit models with a body lift?

No — this is the most important fitment check. APDTY 601313 is not compatible on models with a factory 2" body raise. If your truck has the factory 2" body lift package, you need APDTY 601316 instead. Confirm which configuration your vehicle has before ordering.

What vehicles does APDTY 601313 fit?

APDTY product data lists APDTY 601313 (front left or front right) as compatible with:

  • 2003–2004 Cadillac Escalade
  • 2003–2004 Chevrolet Avalanche
  • 2003–2004 Chevrolet Silverado 1500, 2500, 3500 Pickup
  • 2003–2004 Chevrolet Tahoe
  • 2003–2004 GMC Denali
  • 2003–2004 GMC Sierra 1500, 2500, 3500 Pickup
  • 2003–2004 GMC Yukon

It replaces 85598001 and 15057506. Verify body-lift configuration, position (left/right), and application against the live APDTY compatibility chart before ordering.

APDTY 601313 specifications at a glance

Detail Information
APDTY part number 601313
Product type Front impact crash sensor (SRS)
Mounting Radiator support, front left or front right
Fitment restriction NOT compatible with factory 2" body raise (see APDTY 601316)
Common application 2003–2004 Escalade, Avalanche, Silverado, Tahoe, Denali, Sierra, Yukon
Replaces 85598001, 15057506
UPC 401000022823
Marketplace availability APDTY.com only

How is APDTY 601313 installed?

This is a general overview only — SRS work must follow the vehicle's factory service procedure.

  1. Diagnose first and confirm the SRS code points to the front impact sensor or its circuit.
  2. Confirm body-lift configuration — this sensor is for non-lifted models only.
  3. Follow SRS safety steps. Disconnect the battery and wait the manufacturer-specified time.
  4. Access the sensor at the radiator support, left or right per application.
  5. Install the new sensor, torque the fastener to factory spec, and fully reconnect the connector.
  6. Reconnect the battery, clear codes, and confirm the SRS light goes out.

Important safety warning

APDTY 601313 is a supplemental restraint system (SRS) component. Incorrect diagnosis, wrong parts, or improper installation can prevent proper airbag deployment. Use a scan tool capable of reading SRS codes and follow factory service procedures. If you are not equipped to service the airbag system, have the part installed by a qualified technician.

Frequently asked questions

What does APDTY 601313 replace?

It replaces GM front impact crash sensor numbers 85598001 and 15057506 on compatible 2003–2004 full-size SUV and pickup models without a factory body lift.

Will it fit my truck with a 2" lift?

No. Models with a factory 2" body raise need APDTY 601316 instead. Confirm your body-lift configuration before ordering.

Is this a left or right sensor?

APDTY 601313 covers front left or front right positions — confirm which side matches your vehicle's original sensor location.

Is this an airbag part?

Yes. It is a front impact crash sensor within the SRS. Follow factory airbag safety procedures and diagnose with a scan tool.

Get the correct front impact sensor for your GM truck

A front impact crash sensor is a safety-critical SRS part. APDTY 601313 is a brand-new replacement for GM 85598001 / 15057506 on 2003–2004 Escalade, Avalanche, Silverado, Tahoe, Denali, Sierra, and Yukon models without a factory body lift. Confirm your body-lift configuration and sensor position, and follow factory SRS procedures before ordering.

Buy APDTY 601313 Front Impact Crash Sensor directly from APDTY

Search Our Catalog