How to replace an ignition lock cylinder on a 2000 Dodge Grand Caravan. These procedures are very common on other year/make/models.
 |
APDTY 035814 Ignition Lock Cylinder Assembly w/ New Keys (Non-Transponder Type) |
Removal
1.) Disconnect the negative battery cable. Remove steering column cover retaining screws.
If you are also replacing the Ignition Switch also, you will need to remove the steering column shroud.
1a.) Remove the cable from the parking brake release handle. Remove screws holding steering shroud. Then remove the lower steering column shroud.
1b.) Removing the Ignition Switch, use a No. 10 Torx bit, remove the ignition switch mounting screw. Depress the retaining tab, and gently pry switch from the steering column.
2. With the ignition switch in the RUN position, depress the retaining tab. Remove the lock cylinder.
Installation
To install, reverse removal procedure. Ensure ignition switch and actuator shaft in lock housing are in the run position. The lock cylinder tab will depress only in the RUN position. Check for proper operation of the ignition switch in all positions.
This lock cylinder was very sticky, so I decided to inspect why. After taking this one apart I found excessive wear well above the normal. After talking to the vehicle owner, he has had this problem for quite a while.
